: Check for step-by-step videos on YouTube for the specific kit name to see the spatial orientation of parts like "Miter Gears" or "Quad Block Mounts".
If you are missing the full PDF manual for this specific image, you can typically find it here: GlafiraE015_058.jpg
: Use the provided screws (often 8mm or 11mm length) to tighten all frame connections once the alignment is correct. 🔍 Where to find specific guides : Check for step-by-step videos on YouTube for
Check for "slack"—if the shaft slides too much, move the 6mm shim to the other side of the bearing. The (e
The (e.g., Strafer Chassis, a specific desk name, or vanity)?
Fasten these crossbars to the main side channels (typically at specific holes like hole 2 and 9). : Slide Bearings and Shims onto your shafts.