Ajb0003 Mp4 May 2026

Are you dealing with a (a line dividing two halves of a mold)? Is the part a simple block or a complex curved surface ?

You can add a taper angle directly inside the Extruded Boss/Base feature rather than as a separate, later step. Advantages and Best Practices

The direction the mold opens, defining whether the draft goes inward or outward. Key Drafting Methods Ajb0003 mp4

You can apply drafts to multiple faces at once, reverse the direction, or change the angle after the part is modeled.

The most common method. You select a plane (e.g., top face) to act as the fixed reference, then select the faces to taper. Are you dealing with a (a line dividing

The degree of slant added to the wall (typically 0.5° to 5°+ depending on material/finish).

Tools like "Allow Reduced Angle" help apply draft to complex 3D contours. Advantages and Best Practices The direction the mold

To help me narrow down the best way to apply a draft, could you tell me: